Slide the optical drive into the drive bay until the two screw holes on the right side of the drive line up with the two screw holes on the right side of the drive cage 1. If the computer is connected to a network managed by HP Client Manager, the computer sends a fault notice to the network management application. Match the notch on the module with the tab on the memory socket. This article needs additional citations for verification. While facing the inside of the front bezel, press the two retaining tabs on the right towards the outer edge of the bezel 1 and pull the bezel blank inwards to remove it 2.
|Date Added:||7 October 2016|
|File Size:||30.56 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Solving Hard Drive Problems Power Supply After installing a new processor onto the system board, always update the system ROM to ensure that the latest version of the BIOS hp pro 3500 microtower pc windows xp being used on the computer. HP strongly recommends that all screws removed during disassembly be kept with the part that was removed, then returned to their proper locations.
Figure Rotating the Drive Cage Up Remove the two retainer screws that secure the drive to the bay 1 then slide the drive back and out of the bay miccrotower.
Page Locate the memory module sockets on the system board.
Remove the access panel Access Panel on page Lay the computer on its side with the front facing toward you. Instructions for using the utility are provided in the Troubleshooting Guide. Don’t show me this message again.
Figure Threading the Keyboard and Mouse Cables Screw the lock to aindows chassis using the screw provided. Cables are not properly connected.
Figure Removing the Security Screws Slide the hard drive back to disconnect it from the carrier then lift it up and out of the carrier. Reset the date and time, your passwords, and any special system setups, using Computer Setup. Table D Solving Network Problems continued Network controller stopped working when an expansion board was added to the computer.
If the computer was shipped with Windows Vista or Windows 7 loaded, you will be prompted to register the computer with HP Total Care before installing the operating system. Page 57 If you are removing a standard PCI card or PCI Express x1 card, hold the card at each end, and carefully rock microower back and forth until the connectors pull free from the socket.
Laptop Computers, Desktops, Printers and more | HP® Australia
Page Place the thermal sensor on top of the hard drive in a position that does not cover the label 1 and attach the thermal sensor to the top of the hard drive with the adhesive strip 2. Not all features listed in this guide are available on all computers.
If the USB flash media Table of Contents Add to my manuals Add. To print the manual completely, please, download it.
List of Hewlett-Packard products – Wikipedia
Windows Update automatically installs the driver when the computer has an internet connection. Exit the operating system. Data4— Hot Pug Detect T. While holding the latch down, slide the drive forward until it stops, then lift the drive up and out of the bay 2.
On some models, the media card reader does not include a port or cable.
Welcome to HP Customer Support
For systems with a graphics card: Processor Microtoower the computer for disassembly Preparation for Hp pro 3500 microtower pc windows xp on page Turn on the monitor and check that the monitor light is on. Cable Management Connect external cables to the installed card, if needed. Installing A Drive Into The 3. Speaker Prepare the computer for disassembly Preparation for Disassembly on page Page Table D-4 Solving Media Card Mucrotower Problems continued After installing the media card reader and booting to Windows, the reader and the inserted cards are not recognized by the computer.
Never crease or bend a SATA data cable tighter than a 30 mm 1. Removing an Internal 3. If you are removing a standard PCI card or PCI Express x1 card, hold the card at each end, and carefully rock it back and forth until the connectors pull free from the socket.
To locate a reseller or dealer near you, visit http: Allows you to exit Computer Setup without saving changes. Microsoft and Windows are hp pro 3500 microtower pc windows xp of Microsoft Corporation in the U. Slide the replacement battery into position, positive side up.
Remove the screw from the rear of the carrier 1 and slide the top cover off the carrier 2. Adjust the monitor brightness and contrast controls. Figure Securing the Cable to windoes Fixed Object Thread the keyboard and mouse cables through the lock. Page 58 If you are not installing a new expansion card, install an expansion slot cover to close the open slot. To assist you in resolving problems online, HP Instant Support Professional Edition provides you with self-solve diagnostics.
Fill out the form, click the Begin button, and follow the instructions on the screen. Page On the rear panel of the computer, lift the slot cover latch 1 and rotate slot cover up and away from the slots 2. Please help improve this article hp pro 3500 microtower pc windows xp adding citations to reliable sources. Best used when unable to 33500 to the internet or when no other solution is available. Product Features Two different chassis are available—microtower and small form factor.
Cause Hp pro 3500 microtower pc windows xp Monitor is not turned on and the monitor light is not on. Mouse may need repair. Remove the two screws that secure the hard drive cage to the chassis. The hard drive is located beneath the power supply. Installing a Security Lock